(06-14-2015, 08:40 PM)Deak Phreak Wrote: It sounds like maybe the edited file got messed up when you modded it which broke running anything. I can't say for sure though. At this point, you may need to SSH in to the device for shell access so you can start to debug it and can then flash the original firmware back if you need to.
well i ordered the wire and took the innotab 3s+ apart but i cant get the solder to connect to the board i get it hot and put the wire down on the board and it doesnt stick so i dont know what to do theres no way of loading the flash some other way
Edit: I tried to use superglue but was unable to get anything on the black command prompt so I gave up I think I'm going to try and return it. ill upload the backup file for innotab 3s+ after I get the new innotab I think ill leave the firmware to you I don't want to mess it up again
