11-15-2018, 05:42 PM
I have got my hands on a LeapPad Ultimate. Tried to do the usual routine with DFTP>surgeon>flash, but I cannot get surgeon to work.
I see that elinux mentions an alternate flashing procedure (using fuse updater) and googling shows that some of you were using that for flashing LeapTV. As Ultimate seems to have a similar architecture to LeapTV (the main chip is the same), could someone share the procedure for flashing firmware with fuse?
Unfortunately, the touch screen and the cart slot are not working well anymore (don't ask), so this might limit my options. Still I have a serial connection, if that is needed.
I see that elinux mentions an alternate flashing procedure (using fuse updater) and googling shows that some of you were using that for flashing LeapTV. As Ultimate seems to have a similar architecture to LeapTV (the main chip is the same), could someone share the procedure for flashing firmware with fuse?
Unfortunately, the touch screen and the cart slot are not working well anymore (don't ask), so this might limit my options. Still I have a serial connection, if that is needed.